how to cut versetta stone panels

Best answer

Pre-drill the panelwith a masonry drill bit,then use caulk and a little stone dust to conceal the fasteners. Collect the dust from your saw table,or make stone dust,cutting a Boral Versetta Stone scrap with a grinder. Be sure to wear the proper safety equipment and follow the tool manufacturer鈥檚 instructions during this step.

People also ask

  • How do you install versetta Stone Fasteners?

  • 聝 Starting at the bottom of the wall, position the first panel, with nailing flange up, and tongue into the Starter Strip. 聝 Fasten panel with a total of 4 Versetta Stone Fasteners in the top nailing flange. A minimum of 2 fasteners must penetrate framing, end fasteners must be located within 3鈥?of the end of the panel.

  • What is versetta Stone tight cut pattern?

  • Versetta Stone Tight Cut pattern gives you the sophisticated look of expertly cut and fitted stones in a panel that installs with screws or nails. It鈥檚 an efficient way to raise the bar on curb appeal.

  • Why choose versetta stone veneer?

  • Our cement-based, manufactured stone veneer panels are meticulously crafted with premium materials to provide years of low maintenance and beauty Versetta Stone 8鈥?x 36鈥?panels leave little waste on the floor. That helps reduce landfill usage while saving you money on the job.

  • How do you cut versetta stone for a fireplace?

  • For a creative and unique look, cut an 8鈥?trim stone down to two 4鈥?pieces. This works for applications like smaller fireplaces, located in more narrow spaces, so that you can leave more room for Boral Versetta Stone panels on each side.

    Leave a Reply

    Your email address will not be published. Required fields are marked *

    Related Posts -