admin

how to cut versetta stone panels

Best answer


Pre-drill the panel with a masonry drill bit, then use caulk and a little stone dust to conceal the fasteners. Collect the dust from your saw table, or make stone dust, cuttinga Boral VersettaStonescrap with a grinder. Be sure to wear the proper safety equipment and follow the tool manufacturer鈥檚 instructions during this step.

People also ask


  • How do you install versetta Stone Fasteners?

  • 聝 Starting at the bottom of the wall, position the first panel, with nailing flange up, and tongue into the Starter Strip. 聝 Fasten panel with a total of 4 Versetta Stone Fasteners in the top nailing flange. A minimum of 2 fasteners must penetrate framing, end fasteners must be located within 3鈥?of the end of the panel.

  • Why choose versetta stone veneer?

  • Our cement-based, manufactured stone veneer panels are meticulously crafted with premium materials to provide years of low maintenance and beauty Versetta Stone 8鈥?x 36鈥?panels leave little waste on the floor. That helps reduce landfill usage while saving you money on the job.

  • What is versetta Stone tight cut pattern?

  • Versetta Stone Tight Cut pattern gives you the sophisticated look of expertly cut and fitted stones in a panel that installs with screws or nails. It鈥檚 an efficient way to raise the bar on curb appeal.

  • What is versetta stone made of?

  • Heat, cold, rain and wind 鈥?Versetta Stone is engineered to perform in all of it. Our cement-based, manufactured stone veneer panels are meticulously crafted with premium materials to provide years of low maintenance and beauty Versetta Stone 8鈥?x 36鈥?panels leave little waste on the floor.

    Leave a Reply

    Your email address will not be published.

    Related Posts -